Thread: My first razor arrived today: surface rust

Hello, I took a gamble with my first razor. I bought it on ebay. The purchase was actually a set. The set included a DOVO Bismarck 6/8 with a bone handle, a Dovo XL strop, and a Norton 4/8K water stone. I paid 200 (expecting everything to be in mint condition) Everything looks brand new, and probably is, but there is one little problem....

The add said the the razor and strop had been used once, and the hone had never been used. This all looks true and the razor has clearly never been honed (it is as dull as the day it left the factory). But the razor has some visible surface rust on the tang (near the pin), and very slight pitting on the blade's surface.

This is what I guess happened; the guy bought the razor, tried to shave with a never honed blade, got frustrated, stored it away with a bit of moisture on it, the blade sat there for a few months and developed some surface rust. So this is basically a brand new blade that had been allowed to deteriorate due to poor care.

My questions are: Is a little bit of pitting a big deal? Will this likely spread all over and further deteriorate the blade? Should I just try to get my money back? Is it worth just shaving with it, and making sure it doesnt spread, and getting it refinished down the road? Basically, I have no idea how common this is, or how big of a deal this should be to me. (keeping in mind the price I paid for it)

Any replies would be much appreciated. Thanks.

Tristan

200 USD (I presume you meant said currency) is simply too much for that kit. Take a look at Straight Razor Designs, The Finest In Gentlemens Shaving And Grooming Needs and you will see that you can get similar or better kit for the same or less money. While pitting is not bad in itself, I would still try to get my money back, as "used only once" clearly indicates "is basically in factory condition".

Just to clarify. You def. cannot get this set for cheaper on classic shaving or straight razor designs. The razor itself is 176.99 on classic shaving (they don't have this specific razor on straight razor designs (oh and that price does include sharpening)), the strop is 64.99, and the hone is 75. So, I don't agree with the last post.

But I do think you are right that I should try to return it.

If the pitting isn't deep,and will mostly polish out, I'd clean the blade and send it to a specialist to get it properly honed to 'shave ready' condition and start using it. If you bought the gear new it would cost more and anyway, nothing much stays perfect forever.

You can just get some 800 grit sandpaper and sand off the rust. Might even be able to get to it with a scotch pad. Its on the tang, so its not exactly that important as long as you remove the active oxidation.

If the rust was not mentioned or shown in a photo, I would ask for a partial refund to defray the cost of correcting it.

If you were able to post a photo of the razor's blade that would be helpful. From your description it doesn't sound too bad to me. As long as the pitting is not in the area of the edge. If it is in the edge and is deep enough when you hone it will just keep leaving areas of micro chipping. Other then that I would probably keep it. Rust in the tang area isn't a major issue with me.

use maas and see it cleans up.If you think it is a good deal try to keep it.Rust close to pin is not a big deal.As you said blade actually doesn't have rust has pitting .Maas will take care of pitting and you will loose your 5 minutes time.

Thanks so much for all of the great ideas. Where do I get this MAAS cream? Home Depot only carries Brasso, and I hear MAAS works way better.

Thanks again

Maas, Flitz, Simichrome, Neverdull, all good brands.