View RSS Feed


How I Make Duck Scales 4

Rate this Entry
by , 07-01-2014 at 04:50 AM (986 Views)
Continue to the other side:
Name:  Wonderedge Ebony (35).jpg
Views: 3735
Size:  51.3 KB

Now here is where it gets TRICKY!

Go UP in sandpaper grit and continue to sand. I use 400 to 600 or even 1200 depending on how close I am getting to the final shape.

REMEMBER if you go too far you have to start over again!

It is pretty easy to take off wood but not so much to add it! J

Sand a few strokes then test fit.

Sand, test, sand, test, sand, test, sand, test… <

You get the idea….


Pretty Close:
Name:  Wonderedge Ebony (36).jpg
Views: 184
Size:  28.6 KBName:  Wonderedge Ebony (37).jpg
Views: 184
Size:  66.5 KB
Time to make SURE your inlays
are fitting correctly!
Name:  Wonderedge Ebony (38).jpg
Views: 175
Size:  33.1 KBName:  Wonderedge Ebony (39).jpg
Views: 174
Size:  22.0 KB
They should be like a glove and just fall into place when you place them on the scales. This will be VERY important later when you are gluing them on!!!!

Name:  Wonderedge Ebony (40).jpg
Views: 172
Size:  22.4 KBName:  Wonderedge Ebony (41).jpg
Views: 178
Size:  28.5 KB

This is BETTER:
Name:  Wonderedge Ebony (42).jpg
Views: 180
Size:  24.1 KB

Let’s see what it looks like:
Name:  Wonderedge Ebony (43).jpg
Views: 177
Size:  52.9 KB
NO finish is on here yet.
See how flat they are lying on the scales?

Name:  Wonderedge Ebony (44).jpg
Views: 176
Size:  27.3 KB
This is really close. A bit more shaping and then seal the scales with your choice of finishes.
I would suggest CA. Follow gssixgun (Glen's) tutorial and you will have a PERFECTLY protected result.



THANK YOU to all the members on SRP who are willing to share their vast knowledge on everything straight razor related!

A HUGE THANK YOU to 10pups!

Without him encouraging me and answering my questions I would have been LOST for a LONG time!

Check out his video tutorial here:10Pups restores a Reaper.

©Chevhead 2014
str8fencer, 32t, Hirlau and 2 others like this.

Updated 07-01-2014 at 07:12 AM by Chevhead



  1. Hirlau's Avatar
    Thank you for taking the time to walk us through the process Chevhead,
    Chevhead likes this.
  2. Chevhead's Avatar
    Quote Originally Posted by Hirlau
    Thank you for taking the time to walk us through the process Chevhead,
    My pleasure!
    Hope someone can use this...