Thread: Jockeys restores some razors!

Whoa. Never seen anyone actually hold the blade off of a surface while dremeling it. BE CAREFUL!! I hold down the blade on a flat surface with magnets holding it down as well. And the dremel NEVER spins into the edge.

Wow! Jockeys, I am very concerned about your hands. Not only are you spinning the wheel into the edge, but your doing it free hand!

Can you post finished pictures in this thread too? I'm interested in seeing the final results. And just making sure, but there was no rust on either razor?

Good videos jocky.
Love the picture of the pig in the tub ....

Originally Posted by Leighton

And just making sure, but there was no rust on either razor?

there was no rust after i was done. there was quite a bit before i started. i will try to take some pictures when i'm done, there were more razors and i haven't had time to totally finish them.

Originally Posted by broncobob

Good videos jocky.
Love the picture of the pig in the tub ....

my wife painted that. she's doing the backup shave den all in pigs, i don't know why...

The wire brush you were using, whats it made from? steel? brass? the nylon one?

Originally Posted by Leighton

The wire brush you were using, whats it made from? steel? brass? the nylon one?

no clue. steel i think.

Great videos! I like how you keep you buffing rag handy by wearing it. I do the same thing.

Oh, it is pronounced jenko (it was previously Geneva Cutlery Co. in Geneva, NY).

Brad

wonderful work!
concise
sound is good
visual is good
Thanks for the effort in the vids...and sharing the excitement
Tom

Can the Dremel be used for razors in worse condition?